Inner West · AS 3660.1
Almost entirely residential and wrapped by Iron Cove on the Parramatta River, Rodd Point in postcode 2046 needs its termite barrier fitted before the slab closes over damp foreshore ground.
Quick answer
Yes, a new home or major rebuild in Rodd Point needs a termite management system under the NCC, since it sits in a termite-prone area. The barrier is installed to AS 3660.1 before the concrete pour, with collars fitted to every pipe and conduit penetration. A durable notice for the meter box and an installation certificate for the certifier both follow, and are required before the Occupation Certificate.
Termite barriers in Rodd Point
Rodd Point is a small, quiet suburb on the western shore of Iron Cove, part of the Parramatta River, within the City of Canada Bay and about 6.1 km west of the CBD. Rodd Island sits just offshore, Rodd Park occupies the tip of the point with the Rodd Point memorial and the Dobroyd Aquatic Club, and the Bay Run walking and cycling track passes close by along the water. With almost no commercial activity, building work here is mostly renovations, rear extensions and the occasional knockdown rebuild of an older waterside home, and every one of those projects still needs a compliant termite barrier before its slab is poured.
Water on several sides is the defining feature for barrier work at Rodd Point. Foreshore land, parks and established gardens hold moisture well back from the cove itself, and that damp ground is exactly what subterranean termites forage through looking for timber. Because the suburb is almost entirely residential, the pest and termite picture starts and ends at the house: sub-floors, roof spaces, gardens and fence lines carry far more weight here than any nearby shopping strip. We plan each barrier around that waterside setting rather than treating it as a standard inland block.
Reviewed by Ismail, founder · Inner West coverage · Updated September 2026 · More Inner West suburbs
Get my fixed quote
Local conditions
Three conditions shape how a Rodd Point barrier gets detailed.
Being wrapped by Iron Cove on the Parramatta River keeps soil damp well back from the water's edge. Subterranean termites forage through ground like that, so foreshore and near-foreshore blocks get a full, continuous perimeter rather than a partial run.
Rodd Point's gardens and parkland have had decades to mature, and older plantings hard against brickwork can hide a termite route into the frame that has nothing to do with a new slab. We check what already exists on the block before finishing the design.
With little commercial activity nearby, termite pressure at Rodd Point comes from the house and garden itself rather than a shopping strip or food outlet. That keeps our attention on sub-floors, roof spaces and fence-line vegetation on every job here.
What we install here
Rodd Point work is mostly renovations, rear extensions and knockdown rebuilds of older waterside homes, with the occasional new build on a cleared block. Waffle pod and raft slabs suit most sites, and we fit collars to every penetration with the perimeter run to the true boundary rather than the slab edge alone. On blocks closer to the cove we pay extra attention to soil moisture and any retaining near the foreshore. We schedule around the plumber's rough-in and the pour date, working to your builder's program throughout.
Local knowledge
Nield Park sits close to much of our Rodd Point work, its lawns, trees and leaf litter a sign of how much moisture the suburb's foreshore parks hold year-round. Shoreline parks around Iron Cove add to that picture on almost every block near the water. Leichhardt Park Aquatic Centre, across the cove, keeps irrigated grounds that add further moisture to the district, while Leichhardt North light rail station is far enough away that it is the cove itself, not transport corridors, that drives most of what we plan around here.
Rodd Point is certified through the City of Canada Bay. Two documents sit between our barrier work and your Occupation Certificate: a durable notice for the meter box, showing the termite system installed, and an installation certificate listing the products, the treated zones and the licensed installer responsible. We turn both around as soon as our stage of a Rodd Point renovation or rebuild is done, so your certifier is never left chasing us for paperwork.
Rodd Point at a glance
| Suburb | Rodd Point, NSW 2046 |
|---|---|
| District | Inner West |
| Distance from Sydney CBD | 6.1 km west |
| Certifying council | Sydney CBD Council |
| Standard applied | AS 3660.1 termite management systems |
| Installed | Before the slab pour, then staged through the build |
| Documents supplied | Installation certificate and durable notice |
| Typical builds covered | New homes, knockdown rebuilds, granny flats, duplexes, townhouses |
Systems we install
Every photo below is from one of our own Sydney jobs. We look at your slab design, site and budget, then recommend a system or a combination.
01A termite-resistant sheet laid over the whole prepared footprint before concreting, so termites can't come up through the slab anywhere.
02A sealed collar on every pipe, conduit and service that passes through the slab. These gaps are the most common hidden way in.
03Protection at the slab edge and into the wall cavity, which stops termites building hidden tunnels up the outside of the slab.
04An APVMA-registered termiticide zone in the soil, with an optional pipe network under paving so it can be recharged later without digging.
05Barriers for bearers, piers and raised timber floors on sloping or elevated blocks, where there's no slab to protect.
06Detailing for sandstone cuts, block retaining walls, step-downs and cut-and-fill sites, which are common across Sydney.
Why during construction
A retrofit can only treat around a finished house. A pre-construction system protects the parts nobody will ever be able to reach again.
A barrier put in during the build costs a fraction of a post-construction system, and far less than repairing termite damage.
New houses (Class 1) and outbuildings (Class 10) with termite-susceptible framing need a compliant termite management system.
Pipe penetrations and slab joints can only be fully protected while they're still open, before the concrete goes in.
An under-slab system covers ground that no treatment from outside the finished house can ever reach.
Your certifier needs the certificate and durable notice before issuing the Occupation Certificate. We supply both together.
Documented, compliant protection gives buyers, building inspectors and lenders confidence when the home is sold.
Installation stages
A termite barrier isn't a single visit. Each part goes in when the site is ready for it, and we fit around your plumber, concreter and bricklayer.
Send your plans and slab details. We recommend a system and give you one fixed price that covers every stage.
Collars go on every service once the plumber has set out, then the membrane or soil treatment is installed across the prepared site.
Perimeter and cavity protection is fitted as the brickwork or cladding goes up, so there's no unprotected gap at the slab edge.
Where it's specified, the chemical perimeter or reticulation system is completed around the building before paths and gardens go in.
A durable notice goes in the meter box, and the installation certificate goes to your builder and certifier.
The owner gets simple care instructions and an inspection schedule so the system keeps doing its job for years.
Compare systems
Both can meet AS 3660.1. The best choice depends on your slab type, what surrounds the house and how much ongoing upkeep the owner wants.
Physical protection
Entry-point protection
Soil protection
Top-up protection
Most of the Sydney builds we work on use a combination: physical collars on every penetration plus a physical or chemical perimeter.
For builders & developers
Builders, developers and owner-builders get a fixed quote from plans, a technician who turns up when the site is ready, and paperwork that never holds up sign-off.
Consistent pricing across lots, one point of contact and a full document set for every dwelling.
Missing durable notices and unclear install records are a common reason Occupation Certificates get held up. We hand everything over together so your certifier has it all in one go.
Paperwork
A complete document set for the builder, the certifier and every future owner of the property.
A permanent notice in the meter box showing the system, install date, installer, any chemical's life expectancy and inspection advice.
For: certifier, owner, future owners
Written confirmation of the system and products used, the areas protected and our licence details.
For: builder, certifier, owner
Details of the physical system or termiticide installed, including safety data sheets for any chemicals.
For: builder, owner
How to keep the system working, plus the recommended inspection frequency under AS 3660.2.
For: homeowner
From real jobs
Photos from our own Sydney sites, not stock images. Tap any photo to see it larger.
Membrane barrier across a large residential slab
Barrier work on a Sydney Harbour site
Installation through sandstone excavation
Perimeter barrier and sleeves on a new slab
Waffle pod formwork with collared penetrations
Membrane detailed against a retaining wall
Membrane sealed around a column
Protected slab edge with collar in place
Collared penetrations before the pour
Perimeter barrier on a completed slab edge
Pipe penetrations sealed into the membrane
Collars fixed through mesh before concreting
Google reviews
Real, verified reviews from homeowners and businesses we've worked with.
Pricing
Every build is different, so we don't guess. We price from your plans and give you one fixed written quote. Quoting is free.
After handover
A barrier only works while it stays intact and visible. Pass these on to the owner.
Free fixed quote
Tell us about your build and get a clear, fixed price, fast. We usually reply within 30 minutes during business hours.
Get a fixed quote
Rodd Point questions
Still unsure? Call and talk it through with a licensed technician.
+61 450 515 215Blocks close to Iron Cove sit on consistently damp foreshore ground, which is exactly the condition subterranean termites forage through. We still install a compliant AS 3660.1 barrier on every Rodd Point job, but on foreshore blocks we run a full, continuous perimeter and check soil moisture and any retaining more closely before finishing the design.
Rodd Point falls under the City of Canada Bay, which won't grant an Occupation Certificate until a durable notice is fitted in the meter box and an installation certificate records the products, the treated areas and the licensed installer. Both documents are handed over as soon as our part of the renovation or rebuild is finished.
Often, yes. Many Rodd Point homes are established Federation or waterfront houses with mature gardens built up against the walls over decades. We check that existing timber and garden material before recommending a system, since old plantings and buried offcuts near the foreshore can already carry termite activity into the new build.
In most cases, yes. The National Construction Code requires a termite management system for new houses and outbuildings in termite-prone areas where the primary building elements can be damaged by termites. Sydney is termite-prone, so the system is installed to AS 3660.1 and your certifier asks for the installation certificate and durable notice before the Occupation Certificate is issued.
It depends on slab area, perimeter length, the number of pipe penetrations, the system chosen, site complexity and how many visits the build needs. Send us the plans and we return one fixed written quote covering every stage. Quoting is free.
Nearby
Same crew, same staging and the same certifier-ready paperwork, right across the Inner West.
Service areas
From the Eastern Suburbs and Inner West to the Hills, the Shire and the western growth corridors. Every suburb has its own page with the local ground conditions, the council that certifies the work and the questions builders there ask us.
Slab pour coming up?
Send us your plans today for a fixed quote, or call and talk to a licensed technician about your site.
